New ATV's have a lot of plastic body work. To do any work on these newer machines you need to remove a lot of body panels. Most of the panels are held together with push in plastic rivets. In the past I would have to use the tip of a small screw driver to pry them up and then grab the edge with a pair of needle nose pliers. This was time consuming and often chewed up the head of the rivet.
I ground special notches into the tips of these pliers to grab the edges of the rivets. With this tool I can grab the thin edge of the rivet and pull it out all in one motion. It is much quicker, easier and does not mar the head of the rivet.
No comments:
Post a Comment